agilent_infiniium_54830
This is an old revision of the document!
Table of Contents
Agilent Infiniium 54830 Series
Hardware Upgrade & Software Restore
Tools & Materials Required
- T10 screwdriver
- T20 screwdriver
- small flat blade screwdriver
- 256MB PC-133 SDRAM (2x 128MB or 1x 256MB)
- 40GB or larger IDE 2.5“ HDD (or SSD)
- 4-6 CD-Rs & burner
- Replacement CR2032 battery
Open The Chassis
- Section 6-4 of the service manual
- Remove the 8 T10 screws from the bottom of the unit (sides will spring out)
- Remove the two T20 screws holding on the carrying handle
- Remove the two T20 screws in each of the two rear feet
- Remove the four T40 screws along the top rear of the case
- Slide the top shroud back and away from the unit
Remove the Optical Drive
- Section 6-9 of the service manual
- Disconnect the IDE, power, and audio cables from the optical drive PCB
- Remove the T10 screw and small L bracket from the optical drive support beam (near the front of the unit)
- Pull the optical drive into the unit, tilt it up, and pull it out the top towards the back
agilent_infiniium_54830.1752719864.txt.gz · Last modified: by admin