User Tools

Site Tools


ark1123


Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
ark1123 [2023/02/25 04:14] – [Docs/Links] 64.222.151.119ark1123 [2024/11/14 02:30] (current) – external edit 127.0.0.1
Line 1: Line 1:
-====== Advantech ARK-1123 ====== +====== Advantech ARK-1123H ====== 
-The ARK-1123 is one of many in a series of Advantech ARK industrial computers. These are small footprint and high reliability systems. There are a few different variants - the main differentiators being the CPU and ports available.+The ARK-1123H is one of many in a series of Advantech ARK industrial computers. These are small footprint and high reliability systems. There are a few different variants - the main differentiators being the CPU and ports available
 + 
 +The ARK-1123H is based on the [[https://www.advantech.com/en-us/products/460a67de-a7c8-94dc-0809-336fd7570e46/mio-2263/mod_3c9191fb-edf1-49a5-a58c-b4734867ecda|MIO-2263]], mounted on a board marked AMO-M010 in a custom enclosure. The AMO-M010 board provides the system with a bit more IO: a second ethernet NIC (an i210, same as on the MIO), 3.5mm line in and line out, a DE-9 port that supports RS-232/422/485, a USB2.0 port, a power button, and power/HDD indicator LEDs.
 ===== Docs/Links ===== ===== Docs/Links =====
  
Line 9: Line 11:
 ===== General Notes ===== ===== General Notes =====
 ==== Specs ==== ==== Specs ====
-  * Intel Atom E3805 2x 1.33GHz +  * Intel Celeron J1900 4x 2GHz 
-  * 2GB RAM (DDR3L @ 1600MHz+  * 4GB RAM (DDR3L, one slot
-  * 8GB eMMC (Kingston W32508) +  * 2.5" SATA, anyHalf-Height mSATA available
-  * 2x Realtek RTL8101 at 10/100. Port 1 (eth0) supports PoE power input! +  * 2x Intel i210AT gigE
-  * [[https://www.silabs.com/documents/login/data-sheets/RS9113_Module_Family_Datasheet.pdf|SiLabs RS9113]] WiFi+Bluetooth over SDIO +
-  * [[https://www.u-blox.com/en/product/ubx-m8030-series?legacy=Current#Document-&-resources|Ublox UBX-M8030]] GNSS - connected at /dev/ttyHS1 +
-  * ZigBee 2.4GHz - Attached at /dev/ttyHS0 ([[https://www.silabs.com/documents/public/data-sheets/TG-PM-0509-ETRX358x.pdf|SiLabs ETRX3587HR]]) +
-  * CAN bus on /dev/ttyACM0 - Atmel ATSAME70N19A-CNT. Exposed on 3pin Phoenix header on the side.  +
-  * Environmental Sensors +
-    * ST Micro HTS221 - Temperature +
-    * ST Micro LNG2DMTR - Accelerometer +
-    * ST Micro LPS22HB - Barometric Pressure  +
 ==== Available External Interfaces ==== ==== Available External Interfaces ====
   * 2x RJ-45 Ethernet   * 2x RJ-45 Ethernet
-  * 1x USB 3.0 (600mA) +    * LAN1 is on the MIO (HDMI side) 
-  * 1x USB 2.0 (400mA) +    * LAN2 is on the AMO (DE-9 side) 
-  * SMA-F for GNSS/WiFi+BT +  * 1x USB 3.0 
-  * SMA-F for Zigbee +  * 2x USB 2.0 
-  * (2x additional openings for SMA available) +  * 4x SMA openings for RF connectors 
-  * 3 pin phoenix connector for CAN bus +  * 2x 3.5mm audio line-level in and out 
-  * 3 pin phoenix connector for power 12-57v DC (plus ignition detection) +  * DE-9 RS-232/422/485 
-  * 3.5mm jack for external intrusion detection +  * 2x HDMI
-  * uSD slot behind screwed down door +
-  * 3x LEDs +
-      * Power LED (orange/green, shows generic status info) +
-      * "Antenna" LED (green, not sure how it's controlled) +
-      * "Cloud" LED (green, controlled by end user though GPIO sysfs) +
 ==== Available Internal Interfaces ==== ==== Available Internal Interfaces ====
-  * 4 pin JST micro connector for ttyS0 (115200,8n1 for boot console+  * 1x full height miniPCIe (w/ USB
-  * MiniPCIe connector (not soldered, likely needs additional hardware+  * 1x half height miniPCIe (mSATA only
-  * Four switches exist inside the device (two switch modules) but it is not yet clear exactly what they do +  * 1x USB 2.0 header
- +
 ==== Update Firmware ==== ==== Update Firmware ====
 This may need to be done on one of the original dell-provided images. I'd recommend upgrading firmware before installing another OS. This may need to be done on one of the original dell-provided images. I'd recommend upgrading firmware before installing another OS.
Line 451: Line 436:
 02:00.0 Ethernet controller: Intel Corporation I210 Gigabit Network Connection (rev 03) 02:00.0 Ethernet controller: Intel Corporation I210 Gigabit Network Connection (rev 03)
 </code> </code>
-=== lsusb ===+==== lsusb ====
 <code> <code>
 Bus 002 Device 001: ID 1d6b:0003 Linux Foundation 3.0 root hub Bus 002 Device 001: ID 1d6b:0003 Linux Foundation 3.0 root hub
ark1123.1677298490.txt.gz · Last modified: 2024/11/14 02:30 (external edit)

Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki