edgegateway3002
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| edgegateway3002 [2023/02/24 18:07] – [UEFI Access] millerjs | edgegateway3002 [2024/11/14 02:30] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 9: | Line 9: | ||
| ===== General Notes ===== | ===== General Notes ===== | ||
| + | ==== Specs ==== | ||
| + | * Intel Atom E3805 2x 1.33GHz | ||
| + | * 2GB RAM (DDR3L @ 1600MHz) | ||
| + | * 8GB eMMC (Kingston W32508) | ||
| + | * 2x Realtek RTL8101 at 10/100. Port 1 (eth0) supports PoE power input! | ||
| + | * [[https:// | ||
| + | * [[https:// | ||
| + | * ZigBee 2.4GHz - Attached at /dev/ttyHS0 ([[https:// | ||
| + | * CAN bus on / | ||
| + | * Environmental Sensors | ||
| + | * ST Micro HTS221 - Temperature | ||
| + | * ST Micro LNG2DMTR - Accelerometer | ||
| + | * ST Micro LPS22HB - Barometric Pressure | ||
| + | |||
| + | ==== Available External Interfaces ==== | ||
| + | * 2x RJ-45 Ethernet | ||
| + | * 1x USB 3.0 (600mA) | ||
| + | * 1x USB 2.0 (400mA) | ||
| + | * SMA-F for GNSS/ | ||
| + | * SMA-F for Zigbee | ||
| + | * (2x additional openings for SMA available) | ||
| + | * 3 pin phoenix connector for CAN bus | ||
| + | * 3 pin phoenix connector for power 12-57v DC (plus ignition detection) | ||
| + | * 3.5mm jack for external intrusion detection | ||
| + | * uSD slot behind screwed down door | ||
| + | * 3x LEDs | ||
| + | * Power LED (orange/ | ||
| + | * " | ||
| + | * " | ||
| + | |||
| + | ==== Available Internal Interfaces ==== | ||
| + | * 4 pin JST micro connector for ttyS0 (115200,8n1 for boot console) | ||
| + | * MiniPCIe connector (not soldered, likely needs additional hardware) | ||
| + | * Four switches exist inside the device (two 2 switch modules) but it is not yet clear exactly what they do. | ||
| - | ==== Local Access ==== | + | No user upgradable RAM/ |
| - | The 3002 was designed to be accessed entirely over a network, and has no end user ways to accessing a local console. Under the lid there is a four pin JST micro connector that can be used to access ttyS0, which has console output on boot. This is a 1v8 UART running at 115200,8n1. | + | ==== Local Console |
| + | The 3002 was designed to be accessed entirely over a network, and has no end user ways to accessing a local console. Under the lid there is a four pin JST micro connector | ||
| {{:: | {{:: | ||
| Line 57: | Line 92: | ||
| - | ===== Specs & Hardware ===== | + | ===== Hardware |
| - | * Intel Atom E3805 2x 1.33GHz | + | |
| - | * 2GB RAM (DDR3L) | + | |
| - | * 8GB eMMC (Kingston | + | |
| - | * 2x Realtek RTL8101 at 10/100. Port 1 (eth0) supports PoE power input! | + | |
| - | * [[https:// | + | |
| - | * [[https:// | + | |
| - | * ZigBee 2.4GHz - Attached at /dev/ttyHS0 ([[https:// | + | |
| - | * CAN bus on / | + | |
| - | * Environmental Sensors | + | |
| - | * ST Micro HTS221 - Temperature | + | |
| - | * ST Micro LNG2DMTR - Accelerometer | + | |
| - | * ST Micro LPS22HB - Barometric Pressure | + | |
| ==== lshw ==== | ==== lshw ==== | ||
edgegateway3002.1677262056.txt.gz · Last modified: (external edit)