quectel_lg290p
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| quectel_lg290p [2025/02/04 22:54] – [Configuration] millerjs | quectel_lg290p [2025/02/20 13:56] (current) – [Resources] millerjs | ||
|---|---|---|---|
| Line 3: | Line 3: | ||
| - | ==== Configuration ==== | + | ===== Configuration |
| - | === Base === | + | ==== Base ==== |
| The LG290P is put into base station mode with a few commands and reboots. The unit can self-survey or known ECEF coordinates can be provided. | The LG290P is put into base station mode with a few commands and reboots. The unit can self-survey or known ECEF coordinates can be provided. | ||
| Line 29: | Line 29: | ||
| There are a number of different ways to configure the LG290P for base station mode, this is just one I have found to work well for me. Read the base station application note for more detailed information and options. | There are a number of different ways to configure the LG290P for base station mode, this is just one I have found to work well for me. Read the base station application note for more detailed information and options. | ||
| - | === Rover === | + | ==== Rover ==== |
| The default configuration of the LG290P is to operate in rover mode. The easiest way to enter this mode is to reset the unit to defaults. | The default configuration of the LG290P is to operate in rover mode. The easiest way to enter this mode is to reset the unit to defaults. | ||
| '' | '' | ||
| - | The resulting sentences are sent at 10Hz and are quite dense, a baud rate of 460800 is recommended by Quectel. If 10Hz data is not required (or the bandwidth needed is too great) the fix rate can be slowed to once per second, for example, with '' | + | The resulting sentences are sent at 10Hz and are quite dense, a baud rate of 460800 is recommended by Quectel. If 10Hz data is not required (or the bandwidth needed is too great) the fix rate can be slowed to once per second, for example, with '' |
| + | ==== Misc. Commands/ | ||
| + | ==== Baud Rate ==== | ||
| + | It may be necessary to adjust the baud rate for one of the three UART interfaces. This is done with the '' | ||
| + | ^ Baud ^ Command | ||
| + | | 921600 | ||
| + | | 460800 | ||
| + | | 115200 | ||
| + | | 9600 | '' | ||
| ==== Resources ==== | ==== Resources ==== | ||
| + | * [[https:// | ||
| * [[https:// | * [[https:// | ||
| * {{ : | * {{ : | ||
quectel_lg290p.1738709687.txt.gz · Last modified: 2025/02/04 22:54 by millerjs